Sample Underfloor Heating & Solar Panel system quotation

Our Reference QUJF0107 –Underfloor Heating – Supply & Install
Solar Panels – Supply & Install
Thank you for the opportunity to provide you with a quotation for your heating project. We propose the use of two underfloor heating manifolds which will be located in the utility room and in a designated position upstairs. Please find below a list of the underfloor heating zones and our quotation.
Manifold 1:
Location:
Zone 1
Utility
Zone 2
Study
Zone 3
Kitchen
Zone 4
Dining
Zone 5
Conservatory
Zone 6
Hall & coat press
Zone 7
Sitting Room
Zone 8
W.C
Manifold 2:
Location:
Zone 1
Main Landing & Hall
Zone 2
Bedroom 3
Zone 3
Bedroom 2
Zone 4
Bedroom 1 & Wardrobe
Zone 5
Bedroom 4
Zone 6
En-Suite
Zone 7
Wardrobe

Underfloor Heating Materials required as follows: (Quotation for supply of equipment ground floor)
Quantity
Item
1
10 loop manifold system
1
11 loop manifold system
4
manifold terminal sets incl. hose connection and air vent
2
Balancing Keys
2
Full mixing kit including, high limit safety stat, 3 speed pump, pump bypass, blending valve, mixing valve, Flow and return isolation valves etc
42
pipe compression fittings for manifold
1500m
16mm Pexal Underfloor Heating pipe.
224m
pipe tracking
3
bag of clips (Qty: 1500)
2
wired control units 1-6 zones
2
Expansion Module Kits
2
pump control units
21
actuating valves
15
Digital thermostats (Programmable time/temperature)
Underfloor Grand Total (Supply & Install)
€7,997.17 + 13.5 % vat
Evactuated Tube Solar Panel System
Thank you for the opportunity to provide you with a quotation for your solar panel project. We propose the use of one high efficiency evacuated tube solar collector (3.52m² solar area in total) feeding hot water into a highly insulated 300L solar domestic hot water cylinder. Please find below a list of the solar system components and our quotation.

Our Partnering company Dalpex also manufactures flat plates which are cheaper but their design team have instructed us to solely use evacuated tubes for Ireland as this country does not get a lot of direct sunlight. Therefore for customers to be satisfied with hot water generation from the solar system, high efficiency evacuated tubes are the preferred choice.




Solar System Materials required as follows: (Quotation for supply & installation of equipment)
Code
Quantity
Item
11512
1
Solar Panel Evacuated Tubes (3.52 m²)
● 25% more efficient than flat plates especially in winter.
● Also heats water when there is no direct sunlight
11523
1
Roof brackets for inclination of 45 degrees
(Solar Panels to be mounted on roof)
11505
1
Digital control unit system for 3 inputs & 2 outputs.
Shows at any time temperature inside the cylinder
(top and bottom) and also temperature of the water
In the roof panels.
11850
1
Solar station including grunfos 25/60 pump, flow regulator,
pressure valve, safety valve etc
11865
3
Heat conduction paste
11867
2
Sensor supports
11427
1
40 Litre Expansion Vessel
11934
1
12 Litre Expansion Vessel (Sanitary)
11821
1
Flexible Hose for Expansion Vessel
11822
1
Expansion Vessel Fixing with non return valve
11719
1
Mixing Valve to deviate between hot water and heating
11909
10 Litres
Glycol
11410
1
300 Litre Solar Panel Cylinder
Solar System Supplied & Installed (by approved solar contractor) to finished working system
€5,795.84
Note the above figures are quoted including discount and excluding VAT @ 13.5%.
2 to 3 weeks for installation upon receipt of order. I hope this is to your satisfaction and if you require any further information please do not hesitate to contact us.
Regards,
Heating Solutions
Mechanical Engineer
Jack Foley
0863823062
www.heating-solutions-ireland.com